IRON MAN MK 85 helmet FREE update Avengers Endgame Mark LXXXV 3D printable Model Print File LTL from Do3D

do you have a quick tutorial on how to put the motorized pieces together, im having the biggest brainfart trying to figure out how to put it all together and if i need screws. Thanks!

I do not but its pretty straight forward (I think), the easiest way to figure out what goes where is to dump all of the original (Non-modified) STLs (you can exclude adding the jaw and ear pieces) into Meshmixer, this will show you where all of the parts go.

The issue here is that the geared hole on the servo arms are too big and do not fit the MG90S servos, then the piece that goes into the helmet does not have the holes for the helper arms. The next issue is that same piece seems to be too short. It also seems that the helper arms are too short and when everything is put together it does not open at all. I emailed Do3D about this, I am still waiting to hear back...

I am having the same problem, Did you figure out what is causing the problem.

Did you try reaching out to DO3D directly? If so, did you get a response? I am curious which motor they recommend using and if there's some sort of guide. If not, I am sure I can figure it out with enough time. Just wish they attached some sort of guide.

Did you get a response? I purchased it today and am looking for support on what the original size was for the suit.

I also reached out about consolidating some files I purchased without an account and the account I now have but I don't think I've heard back. It's only been a couple days though.